Why use Pentafloor™?

Our Solutions to Warped Access Floor Panels
High strength cement fill, along with special designed high strength steel corners, gives products by Pentafloor™ the best corner panel loading in the industry.

Most widely used panel design in the world with full strength corners where it is needed most, as well as undergoing rigorous performance testing.

The point of failure or collapse is the single most important indicator of performance. Be sure to look at the ultimate distributed load and concentrated load value when selecting an access floor panel for your application. However, due consideration most be given to ultimate distributed load and concentrated load.

High Strength Corners

Our Panels come with 90 degree drawn steel beam corners, filled with high strength cement. Any load placed on the panel will be transferred to the panel corners before traveling through the pedestals to the sub floor.

Even though our deep drawn beam corner is a difficult manufacturing process, it is done in order to achieve the ultimate loading capacity necessary.

This prevents upward bending of corners or dishing of panels. Cement is injected by high pressure pump to ensure complete saturation of the panel.

The Strength of the corner areas of the panel is the ultimate determining factor for an excellent raised floor system.

Ultimate Load Capacity

Ultimate load capacity is defined as the point at which panel failure occurs. Our panels are designed and built to a minimum safety factor of 2.5 x design load. This prevents failure that could lead to injury or massive equipment damage.

Our Track Record

Click to select range:






Posi Cap Screw Down System

The Posi Cap Screw Down System is ideally suited for installations in general office applications, and features galvanised pedestals that are fastened at the corners ensuring the structure is both ridged and stable. Ideally suited to loose lay carpet tile or vinyl finishes.


Bolt on Stringer System (with Bare panel or HPL finish)

The Bolt on Stringer System, is ideally suited for installations where high finished floor heights are required, in office areas for heavy equipment, and pressurised environments. The system uses stringers to form a solid base that holds the floor and pedestal heads in place when panels are uplifted.


Free Standing System

The Free Standing System is ideal for a general office application. Our specially designed pedestal heads would be finished off with a gasket that is electrically conductive and is fitted to the top of the pedestal head.The advantage is easy access (no screws), and is suited for loose-lay and permanently bonded finishes.


Low Lock Screwdown System

The Low Lock Screwdown System has an identical application to the above sytem and is ideally suited for general office application where height restrictions apply. This system has been specifically designed to facilitate a finished floor height of 80mm -140mm.



Web Statistics